This BackOFF Brake Light Module is unique in that it detects your speed, and automatically turns your brake lights on when you are stopped or stopping allowing you to keep both feet on the ground and both hands free. Easy Installation. - Simply install the Brake-Hold Module in line with the wire leading to the brake light, connect to a switched power source and ground wire, and tap a wire into your bike's ELECTRONIC speed sensor.
Large power capacity: - 12 volts DC - Maximum Capacity: 10 Amps (normally up to 3 bulbs)
The Brake Hold Module connects to your bike's electronic speed pick-up sensor (will not work with cable driven speedometers); to keep your brake lights on when you release your brakes but are still decelerating. In addition, it will turn them on or keep them on when you are are stopped, even if you take your hands and feet off the brakes!
Compact size. - 2-1/4"L x 1-5/8"W x 5/8"H
Sealed Weather Resistant heat sink case
Limited Warranty - One Year!
Your Bike MUST have Electronic Pick-Up Sensor for this module to function
User Selected Mode One:
Emit a visual signal of 3 short light flashes, followed by 1 long light flash (3.5 seconds). The signal automatically repeats itself as long as the brake lights are on. This pattern is not random, but has been selected because of its ability to retain following drivers attention.
User Selected Mode Two:
Emit a visual signal of 5 quick flashes, followed by a steady on light that remains steady as long as the brake lights are on.
If the Brake Hold Module is holding your brake lights on for you and you wish to gain the attention of someone behind you; simply press either brake and your brake lights will flash 5 times then return to steady on.